Problem with Geometry and Mesh module

Use of the platform
1

Hello, I am new to SALOME! After doing a bit on Mesh module, I suddenly understood that I needed to go back to Shaper for changing the geometry. I did, but after that when I’m on either Geometry or Mesh module, the “ShaperResults” section shows the old geometry features before correction.

How to load the new corrected geometry to GEOMETRY and MESH?

2

Hello Hritam,
If the topology of the geometry didn’t change too much, then it is updated in ShaperResults and you just need to recompute the mesh.
Otherwise a new version will be published in ShaperResults while leaving the module.